Fonrich Training Events

For training on installation and maintenance of Fonrich 
products, you've come to the right place
Home » News » Events & Live Trainings

Events

Events & Live Trainings

  • 24 channels, but the upper left corner of the module shows 0. How to judge which Hall is faulty? The method is to insert the cable into each Hall separately, the correct one should display 4, the incorrect one will display 0, replace the Hall with 0.

    2022.01.19

    Read More
  • ① The branch shows a negative current. The negative current is greater than 2A, but when the ruler gauge has no negative current, it needs to be replaced;② No current is displayed on the branch circuit. The current meter measures the current and is greater than 1A, which needs to be replaced;③

    2022.01.21

    Read More
  • Press the "SET" key to enter the Modbus parameter setting interface. The Modbus parameter setting is as follows:

    2022.01.21

    Read More
  • Note: Operate in sequence, do not operate (2) first, then (1), otherwise an arc will occur (1)Disconnect ① circuit breaker; (2)Pull out all positive and negative fuses; (3)Multimeter measurement confirms that the voltage between modules PV + and PV- is 0v; (4)Display all the wiring marks

    2022.01.21

    Read More
  • (1) The Main Controller Module has a black screen. When the multimeter measures a DC voltage between PV + and PV-> 400v, the Main Control Module needs to be replaced.(2) The data of the combiner box cannot be viewed in the background, and the settings (baud rate, parity, address) of the monitori

    2022.01.21

    Read More
  • Total 2 pages  Go to Page
  • Go

Distributor

Products

Support

Fonrich

Copyright  2021 Fonrich (Shanghai) New Energy Technology Co., Ltd. All rights reserved. 
Sitemap    Support By Fonrich.